We took out all of the hard work for you, all you have to do is cut your fret slots that we marked for you. Sand the neck smooth, Paint or Stain the neck and / or cigar box. Tap in the frets we provide and check uneven height with tool we provide. File the fret edges, Glue the neck to the cigar box, install the tuners in the holes we predrilled, tighten the tuner nut and screw the tiny screw in the hole that we pre drilled, screw in the screws for the strings that we pre drilled, install the strings and place the nut in the pre routed slot and place the bridge 25" from the nut and tighten the strings, tune and play.

 

• Coping saw with small thin wood blade.
• (for cutting the fret and box lines we provided )
• Sand paper.
• (to sand the neck smooth.) 
• Wood Paint, Stain, or polyurithan and brush.
• ( for painting or staining the neck and or Cigar Box)
• Plastic/rubber tip hammer.
• (to tap in fret material.)
• Metal file or Dremal tool with a small sanding disc.
• ( to file the rough edges of the frets you install)
• Two Wood clamps
• Titebond III  Ultimate Wood Glue, small bottle.
• ( to glue the cigar box lid to the neck.
• Phillips Screw drivers , Jewelers and Medium tip.
• (to screw in the the tiny tuner screws and string screws)
• Measuring tape.
• ( to measure 25" distance from the nut and bridge)
• Drill (optional) Hole Saw Blade or 1/2" wood drill bit (optional)
• ( if you install sound holes )

These tools and supplies can run up to $70.00 and can make many CBG kits in the future.